Hyundai Azera: Armed stage
Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine.
2.Make sure that all doors, the engine hood and trunk lid are closed and latched.
3.Lock the doors by pressing the switch of the front outside door handle with the
smart key in your possession.
After completion of the steps above, the hazard warning lights operate once to indicate that the system is armed.
If any door remains opened, the doors will not lock and the chime will sound for 3 seconds. Close the door and try again to lock the doors.
If trunk lid or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After the trunk lid and engine hood are closed, the hazard warning lights will blink once.
Lock the doors by pressing the lock button on the smart key or with the mechanical key. After completion of the steps above, the hazard warning lights will operate once to indicate that the system is armed.
If any door, trunk lid or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After the doors, trunk lid and engine hood are closed, the hazard warning lights will blink once.
Do not arm the system until all passengers have left the vehicle. If the system is armed while a passenger( s) remains in the vehicle, the alarm may be activated when the remaining passenger(s) leave the vehicle. If any door, trunk lid or engine hood is opened within 30 seconds after entering the armed stage, the system is disarmed to prevent unnecessary alarm.
Theft-alarm system (If equipped)
Theft-alarm stageStarting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and acc ...
Rear Console Cover Components and Components Location
Component Location
1. Rear console cover
...
Front Door Outside Handle Repair procedures
Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the front door outside handle cover (A).
Tightening torque :
0.7 ~ 0.5 N.m (0.07 ~ 0.1 kgf.m, 1.0 ...