Hyundai Azera: Auto Light Sensor Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Repair procedures
| Inspection |
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light sensor's input.
The auto light control doesn't work if the pin sunlight
supply (5V regulated power from Ignition 1 power to sunlight sensor) is
in short circuit with the ground.
If IGN1 ON, The BCM monitors the range of this supply and
raises up a failure as soon as the supply’s voltage is out of range.
Then this failure occurs and as long as this is present, the head lamp
must be turned on without taking care about the sunlight level provided
by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver.
|
| 3. |
Remove the auto light sensor connector (B). |
| Installation |
| 1. |
Reconnect the auto light sensor connector. |
| 2. |
Install the auto light sensor. |
Schematic Diagrams
Circuit Diagram
...
See also:
Front Disc Brake Components and Components Location
Components
1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer
...
Trunk
...
Repair procedures
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch.
2.
If diagnosis is ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com