Hyundai Azera: Center Pillar Trim Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Interior Trim / Center Pillar Trim Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Interior Trim / Center Pillar Trim Repair procedures
| Replacement |
|
| 1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim") |
| 2. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim") |
| 3. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pins (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B).
|
| 4. |
Remove the center pillar lower trim (A).
|
| 5. |
Remove the center pillar upper trim (A).
|
| 6. |
Installation is the reverse of removal.
|
Center Pillar Trim Components and Components Location
Component Location
1. Center pillar lower trim2. Center pillar upper trim
...
Rear Pillar Trim Components and Components Location
Component Location
1. Rear pillar trim
...
See also:
26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Specifications
Direct control VFS[UD/B]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 500.14 ~ 9.81(5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com