Hyundai Azera: Curtain Airbag (CAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
| 2. |
Remove the roof trim.
|
| 3. |
Disconnect the curtain airbag harness connector (A).
|
| 4. |
After loosening the mounting bolts remove the curtain airbag (A).
|
| Installation |
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Tighten the curtain airbag mounting bolts.
|
| 4. |
Connect the curtain airbag connector. |
| 5. |
Install the roof trim.
|
| 6. |
Reconnect the battery negative cable. |
| 7. |
After installing the curtain airbag (CAB), confirm proper system operation:
|
Knee Airbag (KAB) Module Description and OperationIntake Actuator Description and Operation
Description
1.
The intake actuator is located at the blower unit.
2.
It regulates the intake door by signal from control unit.
3.
Pressing the intake selection switch will shift between re ...
ICM (Integrated Circuit Module) Relay Box Components and Components Location
Component
Input/Output Specification
No.ConnectorNo.Connector1 -11 -2 -12 -3Burglar horn13 -4 -14 -5Engine room box(Horn 15A fuse)15GND6IPM(BCM : Burglar alarm h ...
TPMS Receiver Schematic Diagrams
Circuit Diagram
Connector pin number
Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground
...