Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper.
|
3. |
Disconnect the front fog lamp connector. |
4. |
Replace the front fog bulb (A) turning it in the counterclockwise direction. |
5. |
Remove the front fog lamp (A) after removing the screws (4EA). |
Installation |
1. |
Install the front fog bulb. |
2. |
Reconnect the lamp connector. |
3. |
Install the front wheel housing. |
Inspection |
1. |
Check BCM input/output specification of MFSW using the GDS.
(Refer to Multifunction switch - "Multifunction switch") |
Knock Sensor (KS) Repair procedures
Removal
[Knock Sensor #1 (Bank 1)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the knock sensor connector (A).
3.
Remove the intake man ...
System Setting
Memory Information
Press the key
Select [System]
Select [Memory Information]
This feature displays information related to system memory.
(1) Using : Displays capacity currently in use
(2) C ...
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place. ...