Hyundai Equus Manuals

Hyundai Azera: Front Impact Sensor (FIS) Repair procedures - SRSCM - Restraint - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Impact Sensor (FIS) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A).

3.
Remove the radiator support upper member (A).

4.
Disconnect the front impact sensor connector (A).

5.
Remove the front impact sensor mounting nut (B).
6.
Remove the front impact sensor.
Installation
   
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the radiator upper cover and air duct.
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Components and Components Location
Components ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are ins ...

See also:

Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position. 2. Set the temperature to the extreme hot (HIGH) position. 3. Press the defroster button (). 4. The air conditioning will be turned o ...

Engine Mounting Components and Components Location
Components 1. Transaxle mounting bracket2. Roll road bracket3. Sub frame4. Engine mounting bracket5. Engine mounting support bracket ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com