Side Impact Sensor (SIS) system consists of two Pressure Side
Impact Sensor (P-SIS) which are installed at each center of the front
door module (LH and RH) and two SIS which are installed at each center
pillar nearby (LH and RH) and two rear SIS which are installed in the
rear pillar (LH and RH).
Pressure Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of
deployment through the collision signal of the SIS when the collision
occurred.
Removal
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connec ...
See also:
Smart key functions
1. Door lock
2. Door unlock
3. Trunk open
4. Alarm
With a smart key, you can lock or unlock a door (and trunk) and even start the
engine without inserting the key. Refer to the following, for mor ...
Seat Heater Schematic Diagrams
Circuit Diagram
...
Water Temperature Control Assembly Repair procedures
Removal and Installation
1.
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose")
2.
Disconnect the throttle body water hoses.
(Refer to Fuel System - ...