Hyundai Azera: Front Seat Belt Pretensioner Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures
| Replacement |
|
| 1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
| 2. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim") |
| 3. |
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).
|
| 4. |
After disconnecting the pretensioner connector lock pin,
remove the front seat belt pretensioner connector (A), loosen the
mounting bolts, then remove the front seat belt pretensioner (B).
|
| 5. |
Installation is the reverse of removal.
|
Front Seat Belt Pretensioner Components and Components Location
Component Location
1. Front seat belt pretensioner
...
Height Adjust Components and Components Location
Component Location
1. Height adjust
...
See also:
Repair procedures
Refrigerant System Service Basics
Refrigerant Recovery
Use only service equipment that is U.L-listed and is
certified to meet the requirements of SAE J2210 to remove
HFC-134a(R-134a) from the ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the Reinforcing panel after loosening the ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com