| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the fuel pressure regulator valve connector. |
| 3. |
Measure resistance between the fuel pressure regulator valve terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification�
|
|
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
Description
Canister Close Valve (CCV) is installed on the canister
ventilation line. It seals evaporative emission control system by
shutting the canister from the atmosphere when leakage dete ...
See also:
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay. IPM receives an input ...
Front Door Latch Repair procedures
Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Disconnect the connector (A) and front door latch wiring harness.
3.
Remove the front door latc ...
Heated Oxygen Sensor (HO2S) Schematic Diagrams
Circuit Diagram
...