Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve. |
5. |
Remove the fuel tank air filter assembly after removing bolts (C). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
Installation |
• |
Install the component with the specified torques. |
• |
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting. |
1. |
Installation is reverse of removal. |
Relay Box (Passenger Compartment) Components and Components Location
Components
...
Front Bumper Cover Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Cylinder Head Cover Components and Components Location
Components
1. LH cylinder head cover2. LH cylinder head cover gasket3. RH cylinder head cover4. RH cylinder head cover gasket5. Exhaust CVVT OCV cap
...