Removal |
1. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) |
2. |
Remove the fuel pump service cover (A) in the trunk. |
3. |
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B). |
4. |
Disconnect the fuel feed tube quick connector (C). |
5. |
Lift the vehicle and support the fuel tank with a jack. |
6. |
Remove the center muffler assembly.
|
7. |
Disconnect the fuel filler hose (A). |
8. |
Disconnect the vapor hose quick-connector (A). |
9. |
Remove the parking brake line (A). |
10. |
Remove the fuel tank band installation nuts (A). |
11. |
Remove the fuel tank after removing the fuel tank band (A) as below. |
Installation |
1. |
Installation is reverse of removal.
|
Front Impact Sensor (FIS) Description and Operation
Description
The front impact sensor (FIS) is installed in the Front End
Module (FEM). They are remote sensors that detect acceleration due to a
collision at its mounting location. The primary p ...
Door courtesy lamp
The door courtesy lamp comes ON when the door is opened to assist entering or
exiting the vehicle. It also serves as a warning to passing vehicles that the vehicle
door is opened. ...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...