Hyundai Azera: Steering Column Shroud Panel Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	After loosening the mounting screws, then remove the steering column shroud panel (A).

2.	Disconnect the connector (A).

3.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Steering Column Shroud Panel Components and Components Location

Component Location 1. Steering column shroud panel ...

Crash Pad Side Cover Components and Components Location

Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

See also:

General Information
Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T ...

Front Seat Back Cover Repair procedures
Replacement • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and pan ...

Rain Sensor Repair procedures
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor inpu ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com