Hyundai Equus Manuals

Hyundai Azera: Door Scuff Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Door Scuff Trim Repair procedures

Replacement
   
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]

2.
Disconnect the connector (A).

3.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
4.
After loosening the mounting screw, then remove the rear door scuff trim (A).
[Rear]

5.
Disconnect the connector (A).

6.
Installation is the reverse of removal.
   
Make sure the connector are connected in properly.
Replace any damaged clips.
Door Scuff Trim Components and Components Location
Component Location 1. Front door scuff trim2. Rear door scuff trim ...

Cowl Side Trim Components and Components Location
Component Location 1. Cowl side trim ...

See also:

1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase thro ...

Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is prohibited. 3. However, when the ...

Suspension mounting bolts
Check the suspension connections for looseness or damage. Retighten to the specified torque. ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com