Hyundai Azera: Cowl Side Trim Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Interior Trim / Cowl Side Trim Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Remove the hood latch release handle. (Refer to Hood - "Hood Latch Release Handle")

3.	Detach the clips, then remove the cowl side trim (A).

4.

Installation is the reverse of removal.

•	Replace any damaged clips.

Cowl Side Trim Components and Components Location

Component Location 1. Cowl side trim ...

Front Pillar Trim Components and Components Location

Component Location 1. Front pillar trim ...

See also:

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perfor ...

Fuel Pump Repair procedures
Inspection [Fuel pump] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Check motor operation by fuel pump connector (A) connecti ...

SS-A Solenoid Valve(ON/OFF) Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com