Hyundai Azera: Center Pillar Trim Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Interior Trim / Center Pillar Trim Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

3.	To remove the seat belt anchor pretensioner (C), keep on pushing the lock pins (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

4.	Remove the center pillar lower trim (A).

5.	Remove the center pillar upper trim (A).

6.

Installation is the reverse of removal.

•	Replace any damaged clips.

Center Pillar Trim Components and Components Location

Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

Rear Pillar Trim Components and Components Location

Component Location 1. Rear pillar trim ...

See also:

Front Door Latch Repair procedures
Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. Disconnect the connector (A) and front door latch wiring harness. 3. Remove the front door latc ...

Cylinder Head Cover Components and Components Location
Components 1. LH cylinder head cover2. LH cylinder head cover gasket3. RH cylinder head cover4. RH cylinder head cover gasket5. Exhaust CVVT OCV cap ...

Center Fascia Panel Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Take ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com