Hyundai Equus Manuals

Hyundai Azera: Rear Package Tray Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Package Tray Trim Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[Center]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
Using a screwdriver or remover, remove the rear pillar trim (A).

4.
After loosening the mounting screws, then remove the luggage partition panel (A).

5.
After loosening the mounting screws, then remove the rear package tray trim (A).

6.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Rear Package Tray Trim Components and Components Location
Component Location 1. Rear package tray trim ...

Trunk Trim
...

See also:

Transmitter Repair procedures
Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn't flicker. ...

Oil Level Gauge & Pipe Components and Components Location
Components 1. Oil level gauge2. Oil level gauge pipe3. O-ring ...

Hood Latch Components and Components Location
Component Location 1. Hood latch ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com