Hyundai Azera: Front Seat Shield Inner Cover Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Inner Cover Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Inner Cover Repair procedures
| Replacement |
|
| 1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
| 2. |
Using a screwdriver or remover, remove the front seat shield inner cover (A).
|
| 3. |
Installation is the reverse of removal.
|
Front Seat Shield Inner Cover Components and Components Location
Component Location
1. Front seat shield inner cover
...
Front Seat Back Cover Components and Components Location
Component Location
1. Front seat back cover
...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
General Information
Tightening Torque Table Of Standard Parts
BOLT (Nominal diameter)NUT (Nominal diameter)
BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T ...
Power Mosfet Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
1. Drain2. Dr ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com