Hyundai Azera: Rear Seat Cushion Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the hog-ring clips (A).

3.	After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat cushion and remove the rear seat cushion cover (C).

4.

Installation is the reverse of removal.

•	To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].

Rear Seat Cushion Cover Components and Components Location

Component Location 1. Rear seat cushion cover ...

Rear Back Armrest Components and Components Location

Component Location 1. Rear back armrest ...

See also:

AVN Remote Controller Schematic Diagrams
Circuit Diagram ...

Water Temperature Control Assembly Components and Components Location
Components 1. Water temperature control assembly2. Throttle body water hose3. Gasket ...

Center Fascia Panel Components and Components Location
Component Location 1. Center fascia panel ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com