Hyundai Equus Manuals

Hyundai Azera: Rear Back Armrest Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Back Armrest Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Disconnect the connectors (A), and mounting wireing clips (B).

3.
After loosening the mounting screws, then remove the rear back armrest board (A).

4.
After loosening the mounting bolts, then remove the rear back armrest (A).

5.
Remove the rear back armrest board (A) after loosening the screws on the rear back armrest (B).

6.
Installation is the reverse of removal.
   
•
Make sure the connectors are plugged in properly.
Rear Back Armrest Components and Components Location
Component Location 1. Rear back armrest ...

Rear Back Armrest Cup Holder Components and Components Location
Component Location 1. Rear back armrest cup holder ...

See also:

Components and Components Location
Components 1. Telemetics Unit (TMU)2. AVN or Audio Head Unit3. Room Mirror Switch (Blue Link button, Center button, SOS button)4. Mic5. Roof Antenna (GPS+CDMA) ...

Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety Administration (NHTSA), are attached to alert the driver and passengers of potential risks of the air bag system ...

Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1. Turn the ignition swit ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com