Hyundai Equus Manuals

Hyundai Azera: Front Seat Belt Pretensioner Repair procedures - Front Seat Belt - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Seat Belt Pretensioner Repair procedures

Replacement
   
•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
3.
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connector (A), loosen the mounting bolts, then remove the front seat belt pretensioner (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connector is plugged in properly.
Front Seat Belt Pretensioner Components and Components Location
Component Location 1. Front seat belt pretensioner ...

Height Adjust Components and Components Location
Component Location 1. Height adjust ...

See also:

SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V)TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60.41984.650.3 ...

Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Inspect the PCV vlave operation. (1) Run the ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com