Inspection |
1. |
Open the junction box fuse cover. |
2. |
Insert the hand to the junction box fuse cover hole and remove the crash pad side switch assembly (A) by pushing it.
|
3. |
Disconnect the switch connector. |
4. |
Check for continuity between the terminal No.4 and No.5.
If there is no continuity, replace the fuel filler door open switch. |
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Disconnecting a Device
Press the key
Select [Phone]
Select [Paired Phone List]
From the paired phone list, select the currently connected device and select
the button.
...
Hands Free Switch Schematic Diagrams
Circuit Diagram
...