Hyundai Azera: ICM (Integrated Circuit Module) Relay Box Repair procedures
| Inspection |
| 1. |
There should be continuity between the No.18 and No.17
terminals when power and ground are connected to the No.16 and No.17
terminals. |
| 2. |
There should be no continuity between the No.18 and No.17 terminals when power is disconnected. |
| 1. |
There should be continuity between the No.8 and No.3
terminals when power and ground are connected to the No.5 and No.6
terminals. |
| 2. |
There should be no continuity between the No.8 and No.3 terminals when power is disconnected. |
| 1. |
There should be continuity between the No.1 and No.12
terminals when power and ground are connected to the No.2 and No.11
terminals. |
| 2. |
There should be no continuity between the No.1 and No.12 terminals when power is disconnected. |
ICM (Integrated Circuit Module) Relay Box Description and OperationHeated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available. However, use washer solvent
with antifreeze characteristics ...
Cluster Fascia Panel Components and Components Location
Component Location
1. Cluster fascia panel
...