Hyundai Azera: Windshield Deicer Switch Repair procedures
| Inspection |
| 1. |
The windshield deicer switch inputs can be checked using the GDS. |
| 2. |
To check the input value of windshield deicer switch, select option "IPM". |
| 3. |
Select option "Current Data".
|
| 4. |
To check the input value of windshield deicer switch in force mode, select option.
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the center fascia panel.
|
| 3. |
Remove the heater control unit (A) after removing screws.
|
| Installation |
| 1. |
Install the heater control unit. |
| 2. |
Install the center fascia panel. |
Windshield Deicer Repair proceduresHood Seal Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the hood seal weatherstrip (A).
•
Be careful not to scratch the hood seal weatherstrip.
2.
Installation is the rev ...
CVVT Oil Temperature Sensor (OTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant ...
Transaxle Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...