Inspection |
1. |
The rear glass defogger switch inputs can be checked using the GDS. |
2. |
To check the input value of rear glass defogger switch, select option "IPM". |
3. |
To consult the present input/output value of IPM, "Current
DATA". It provides information of IPM input/output conditions of rear
defogger relay. |
4. |
To check the input value of rear glass defogger switch in force mode, select option "Actuation Test". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the center fascia panel.
|
3. |
Remove the heater control unit (A) after removing screws. |
Installation |
1. |
Install the heater control unit. |
2. |
Install the center fascia panel. |
Cowl Top Cover Repair procedures
Replacement
1.
Remove the cap (B) and remove the nuts, then remove the wiper arm (A).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)
2.
Disconnect the nozzle hose (B). ...
Repair procedures
Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM ...
Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System
(SRS) and the lap/shoulder belts at both the driver and passenger seating positions.
The indications of the system ...