Hyundai Azera: Windshield Wiper-Washer Switch Repair procedures
| Inspection |
| 1. |
The windshield wiper / washer switch inputs can be checked using the GDS. |
| 2. |
To check the input value of windshield wiper/washer switch, select option "MFSW". |
| 3. |
To consult the present input/output value of IPM, "Current
DATA". It provides information of IPM input/output conditions of
windshield wiper / washer switch.
|
| Removal |
| 1. |
Remove the steering column upper and lower shrouds after removing 3 screws.
|
| 2. |
Remove the multifunction switch connector (A).
|
| 3. |
If necessary of removing the wiper & washer switch (A)
only, release the lock of wiper switch using tool without removing the
steering wheel and the clock spring.
|
| 4. |
Remove the steering wheel.
|
| 5. |
Remove the clock spring.
|
| 6. |
Loosen screws (2EA) and remove the multifunction switch assembly (A).
|
| Installation |
| 1. |
Install the multifunction switch. |
| 2. |
Install the clock spring.
|
| 3. |
Install the steering column upper and lower shrouds. |
| 4. |
Install the steering wheel. |
| 5. |
Install the driver airbag module.
|
Components and Components Location
Front Wiper Motor Components and Components LocationDynamic Damper Components and Components Location
Components
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circlip
...
Output Speed Sensor Schematic Diagrams
Circuit Diagram
...
General Information
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Check the battery for damage, state of charge, and clean and tight c ...