Hyundai Equus Manuals

Hyundai Azera: Front Washer Motor Repair procedures - Windshield Wiper/Washer - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Washer Motor Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor Repair procedures

Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
   
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.
3.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
4.
If they are abnormal, replace the washer motor.
No.
Description
No.
Description
1
Ground
2
Windshield washer (+)

Washer Fluid Level Sensor Switch
1.
Disconnect the negative(-) battery terminal.
2.
Drain the washer fluid less than 650 cc.
3.
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the float is up.
4.
If the continuity is not as specified, replace the washer fluid level switch.

Removal
   
-
When servicing the washer pump, be careful not to damage the washer pump seal.
-
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the right tire in the front and wheel cover.
3.
Remove the washer hose (B) and disconnect the washer motor connector (A).

4.
Remove the washer motor.
   
Washer fluid may flow out of the opening of reservoir.
5.
Remove the washer tank (B) after loosening the washer tank mounting bolt (A).

Installation
1.
Install the washer reservoir.
   
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Install the washer motor.
3.
Install the washer hose.
4.
Connect the washer motor connector and level sensor connector.
5.
Install the tire and wheel guide cover.
6.
Check the washer motor operation.
Front Wiper Motor Repair procedures
Removal 1. Loosen the windshield wiper arm nut (B) after removing a wiper cap (A). 2. Remove the windshield wiper arm and blade. 3. If necessary, release the wiper blade fixing clip by pul ...

Rain Sensor Schematic Diagrams
Circuit Diagram ...

See also:

Opening the hood
Open the hood after turning off the engine on a flat surface, move the shift lever to the P(Park) position and set the parking brake. 1. Pull the release lever to unlatch the hood. The hood shou ...

Using USB Mode
Playing/Pausing USB Files Once a USB is connected, the mode will automatically start and begin playing a USB file. While playing, press the key to pause and press again to play. ✽ NOTIC ...

Battery Components and Components Location
Components 1. Battery insulation pad2. Battery3. Battery tray4. Battery mounting bracket ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com