Hyundai Azera: Repair procedures
| Inspection |
Check it by the procedure below to see if the function of the ECM is normal.
| 1. |
Turn the ignition key to the "ON" position. |
| 2. |
Cover the front sensor to stop functioning. |
| 3. |
Shine a light at the rear sensor. |
| 4. |
The ECM should be darkened as soon as the rear sensor detects the light.
|
| 5. |
When the reverse gear is engaged, the ECM should not be darkened. |
| 6. |
When heading lights to both the front and rear sensors, the ECM should not be darkened. |
| Removal |
| 1. |
Remove the mirror wiring cover (A) and disconect mirror connector (B).
|
| 2. |
Remove the mounting screw (A).
|
| 3. |
Remove the mirror (A) pulling up in the arrow direction.
|
| Installation |
| 1. |
Install the mirror making sure the mounting bracket not to be damaged. |
| 2. |
Install the mirror wiring cover after reconnecting the connector and tightening the screw.
|
Description and Operation
Description
The ECM (Electro Chromatic inside rear view Mirror) is for
dimming the reflecting light from a vehicle behind at night, in order
the user not to be dazzled by the light. The forward ...
See also:
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store them ...
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control
actuator based on signal of A/C control unit. Pressing mode select ...
Rear Door Curtain Assembly Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
After loosening the mounting screws, then remove the rear door curtain (A).
3.
Installation is the re ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com