Hyundai Azera: Hazard Lamp Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the center console upper assembly (A) with hazard lamp switch.
|
| 3. |
Remove the heater control unit (A).
|
| 4. |
Disconnect the heater control unit connector (A).
|
| Installation |
| 1. |
Install the heater control unit. |
| 2. |
Install the center console upper assembly. |
License Lamp Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the license lamp (A) with loosening a screw.
Installation
1.
Install the bulb.
2.
Install the license lamp lens. ...
Rheostat Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger compartment juction box cover.
3.
Remove the crash pad side switch assembly (A) by pushing it through ju ...
See also:
Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...
Troubleshooting
Troubleshooting
SymptomSuspect AreaRemedy (Refer to page)Water leaks from sunroofDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAd ...
Relay Box (Engine Compartment) Repair procedures
Inspection
Power Relay Test (Type A)
-
Do not use pliers.
-
Pliers will damage the relays, which could cause the engine to stall or not start.
-
Carefully remove ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com