Hyundai Azera: High Mounted stop lamp Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / High Mounted stop lamp Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / High Mounted stop lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the roof trim.
|
| 3. |
Disconnect the connector (A) of high mounted stop lamp.
|
| 4. |
Remove the high mounted stop lamp (B) after removing the bolts (3EA) and a clip. |
| Installation |
| 1. |
Install the high mounted stop lamp to the roof trim. |
| 2. |
Install the roof trim. |
Front Fog Lamps Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect the front fog lamp connector.
4.
Replace the ...
Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
...
See also:
Fuel Pressure Control Valve (FPCV) Troubleshooting
Signal Waveform
...
Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the hole plug (B).
3.
After loosening the mounting bolt, then remove the rear door outside hand ...
Yaw-rate and G Sensor Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
(Refer the Body - "Floor console")
3.
Disconnect the yaw rate & latera ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com