Hyundai Azera: Auto Light Sensor Repair procedures
| Inspection |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver.
|
| 3. |
Remove the auto light sensor connector (B). |
| Installation |
| 1. |
Reconnect the auto light sensor connector. |
| 2. |
Install the auto light sensor. |
Schematic DiagramsSide Sill Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX (Maximum) and MIN (Minimum) marks on the side of the reservoir.
Before removing the reservoir cap and addin ...
Driving at night
Because night driving presents more hazards than driving in the daylight, here
are some important tips to remember:
Slow down and keep more distance between you and other vehicles, as it may
...