Hyundai Azera: Front Rear Parking Assist System Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel in the driver side.
|
| 3. |
Disconnect the connector and remove the side switch assembly by pushing both hooks.
|
| Installation |
| 1. |
Install the connector and crash pad side switch assembly. |
| 2. |
Install the negative (-) battery terminal. |
Parking Assist Sensor Repair proceduresCompressor Oil Repair procedures
Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed.
2.
Compressor (P ...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide occupants with additional protection
than that offered by the sea ...
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer t ...