Hyundai Azera: A/C Pressure Transducer Repair procedures
| Inspection |
| 1. |
Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals.
|
| 2. |
Inspect the voltage value whether it is sufficient to be regular value or not.
|
| 3. |
If the measured voltage value is not specification, replace the A/C pressure transducer. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Recover the refrigerant with a recovery/charging station. |
| 3. |
Disconnect the A/C pressure transducer connector (A) and then remove the A/C pressure transducer (B).
|
| 4. |
Installation is the reverse order of removal. |
A/C Pressure Transducer Description and Operation
Evaporator Temperature Sensor Description and OperationICM (Integrated Circuit Module) Relay Box Schematic Diagrams
Circuit Diagram
...
Checking the coolant level
Check the condition and connections of all cooling system hoses and heater hoses.
Replace any swollen or deteriorated hoses.
The coolant level should be filled between F (Full) and L (Low) marks ...
SS-B Solenoid Valve(ON/OFF) Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an
on/off solenoid valve that is used to change gears. SS-B Solenoid
valve(ON/OFF) is installed at valve body. ...