WARNING
Do not adjust the clock while driving. You may lose your steering control and cause an accident that results in severe personal injury or death.
Whenever the battery terminals or related fuses are disconnected, you must reset the time.
When the ENGINE START/STOP button is in the ACC or ON position, the clock buttons operate as follows:
Hour (1)
Pressing the H button will advance the time display by one hour.
Minute (2)
Pressing the M button will advance the time display by one minute.
Display conversion
To change the 12 hour format to the 24 hour format, press the “H” and “M” buttons at the same time for more than 5 seconds.
For example, if the time is 10:15 p.m., the display will be changed to 22:15.
❈For the type of clock built in the audio or navigation, refer to a separately supplied manual.
Using Voice Recognition
Starting Voice Recognition
Shortly press the key on the steering
wheel remote controller. Say a command.
If prompt feedback is in [ON], then the system will say “Please say a command
after the ...
SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
SRS components and functions
The SRS consists of the following components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side impact air bag modules
4. Curtain air bag modules
5. Retract ...