This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAWR.
Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the steering wheel.
(Refer to Steering ...
Shift Cable Repair procedures
Removal
1.
Remove the center console assembly.
(Refer to Body - "Console")
2.
Remove the duct (A).
3.
Remove the control cable (B).
4.
Remove the control cable assembly in the vehicle ...
Fuel Pump Repair procedures
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecti ...