Hyundai Equus Manuals

Hyundai Azera: Height Adjust Repair procedures - Front Seat Belt - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Height Adjust Repair procedures

Replacement
1.
Remove the front seat belt upper anchor.
(Refer to Front Seat Belt - "Front Seat Belt Pretensioner")
2.
After loosening the bolts, then remove the height adjustor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connector is plugged in properly.
Height Adjust Components and Components Location
Component Location 1. Height adjust ...

Front Seat Belt Buckle Components and Components Location
Component Location 1. Front seat belt buckle ...

See also:

TJ Joint Components and Components Location
Components [LH] 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...

General Information
Lift And Support Points Lift And Support Points     When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additi ...

Suspension mounting bolts
Check the suspension connections for looseness or damage. Retighten to the specified torque. ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com