1. Open the trunk, and remove the towing hook from the tool case.
2. Remove the hole cover pressing the lower part of the cover on the front bumper.
3. Install the towing hook by turning it clockwise into the hole until it is fully
secured.
4. Remove the towing hook and install the cover after use.
Microphone Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the handsfree mic (A) after disconnect the connector f ...
ICM (Integrated Circuit Module) Relay Box Schematic Diagrams
Circuit Diagram
...
Drive belts
Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation
and replace if necessary. ...