Hyundai Azera: Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use.
Whenever the ENGINE START/STOP button is changed to the ON position, the immobilizer system checks and verifies if the key is valid or not. If the key is valid, the engine will start. If the key is invalid, the engine will not start.
To deactivate the immobilizer system
Change the ENGINE START/STOP button to the ON position.
To activate the immobilizer system
Change the ENGINE START/STOP button to the OFF position.The immobilizer system activates automatically. Without a valid smart key for your vehicle, the engine will not start.
✽ NOTICE
Your immobilizer password is a customer unique password and should be kept confidential. Do not leave this number anywhere in your vehicle.
CAUTION
Keep each key separate in order to avoid a starting malfunction.
CAUTION
Do not put metal accessories near the smart key. The engine may not start because the metal accessories may interrupt the transponder signal from transmitting normally.
If you need additional keys or lose your keys, consult an authorized HYUNDAI dealer.
CAUTION - Immobilizer damage
Do not expose your immobilizer system to moisture, static electricity and rough handling. This may damage your immobilizer.
CAUTION - Immobilizer alterations
Do not change, alter or adjust the immobilizer system because it could cause the immobilizer system to malfunction.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Key operations
Smart keyComponents and Components Location
Components
Rear Seat Back [RH]
1. Headrest2. Headrest guide3. Rear seat back pad4. Rear seat back cover5. Rear seat back pad support wire6. Rear back armrest7. Hinge bracket cover8. Rear seat ...
Panoramaroof Switch Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Check for continuity between the termin ...
Blower Unit Components and Components Location
Component Location
Components
1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...