Specification |
Items | Specification | |
Ignition coil | Primary resistance | 0.75? ± 15 % |
Secondary resistance | 5.9k? ± 15 % | |
Spark plugs | Type | SILZKR7B11 |
Gap | 1.0 ~ 1.1mm (0.0394 ~ 0.0433in.) |
ltems | Specification | ||
Starter | Rated voltage | 12 V, 1.7 kW | |
No. of pinion teeth | 10 | ||
No-load characteristics | Voltage | 11.5 V | |
Ampere | 85A, MAX | ||
Speed | 2,550 rpm, MIN |
Items | Specification | ||
Alternator | Rate voltage | 13.5 V, 150A | |
Speed in use | 1,500 ~ 18,000 rpm | ||
Voltage regulator | IC regulator built-in type | ||
Regulator setting voltage | External mode | ECU control | |
Internal mode | 14.0~15.0V | ||
Temperature compensation | External mode | ECU control | |
Internal mode | -4 ± 4 mV / °C | ||
Battery | Type | 64 - 27 GL | |
Cold cranking amperage [at -18°C (-0.4°F)] | 660 A | ||
Reserve capacity | 145 min | ||
Specific gravity [at 25°C (77°F)] | 1.280 ± 0.01 |
|
|
Items | Specification | |
Operation speed range | 0 ~ 180 km/h (0 ~ 111.8mph) [0 ~ 30 km/h (0 ~ 18mph), If there is ahead car] | |
Sensing angle | Horizontal angle | long distance: 20 ± 1° short distance: 80 ± 5° |
Vertical angle | 4.5° | |
Sensing distance | long distsnce: 1 ~ 174m (3 ~ 570ft) short distance: 1 ~ 50m (3 ~ 164ft) |
Components and Components Location
Component Location (1)
1. Head lamp (Low)2. Head lamp (High)3. Position lamp (LED)4. Front turn signal lamp5. Side marker6. Overhead console lamp (General/Panoramaroof)7. Room lamp (General) ...
Air Ventilation Seat Repair procedures
Removal
[Front Seat]
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the seat back cover and cushion cover.
(Refer to Body - "Front Seat Cushion Cover") ...
Overhead Console Lamp Repair procedures
Inspection
Overhead Console Lamp
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
...