Removal and Installation |
1. |
Disconnect the battery negative terminal. |
2. |
Remove the engine cover. |
3. |
Disconnect the alternator connector (A) and the cable (B) from the 'B' terminal. |
4. |
Remove the drive belt.
|
5. |
Remove the alternator (A).
|
6. |
Installation is reverse order of removal.
|
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Master cylinder
...
AVN Remote Controller Schematic Diagrams
Circuit Diagram
...
Hood Latch Release Handle Repair procedures
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
...