Hyundai Azera: Barometric Pressure Sensor (BPS) Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Description and Operation
| Description |
Barometric Pressure Sensor (BPS) is a speed-density type
sensor and is installed on the air cleaner assemby. It senses absolute
pressure of the air cleaner assemby and transfers the analog signal
proportional to the pressure to the ECM. By using this signal, the ECM
calculates the intake air quantity and engine speed.
The BPS consists of a piezo-electric element and a hybrid IC
amplifying the element output signal. The element is silicon diaphragm
type and adapts pressure sensitive variable resistor effect of
semi-conductor. Because 100% vacuum and the manifold pressure apply to
both sides of the sensor respectively, this sensor can output analog
signal by using the silicon variation proportional to pressure change.
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Barometric Pressure Sensor (BPS) Specifications
Specification
Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)10.0 (0.01, 0.15)0.5055.0 (0.56, 7.98)2.21100.0 (1.01, 14.5)3.93115.0 (1.17, 16.9)4.50
...
See also:
Fuel Filter Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
3.
Remove the cushi ...
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
, ), HomeLink® Channel 1 and Channel
3, until the indicator light begins ...
Smart key receiver Repair procedures
Removal
RF Receiver
-
Take care not to scratch the crash pad and related parts
1.
Disconnect the negative(-) battery terminal.
2.
Remove the rear seat.
(Refer to ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com