Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog signal proportional
to the pressure to the ECM.
By using this signal, the ECM calculates the intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC
amplifying the element output signal. The element is silicon diaphragm
type and adapts pressure sensitive variable resistor effect of
semi-conductor.
Because 100% vacuum and the manifold pressure apply to both
sides of the sensor respectively, this sensor can output analog signal
by using the silicon variation proportional to pressure change.

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Specification
Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)20.0 (0.20, 2.90)0.7946.66 (0.47, 6.77)1.84101.32 (1.03, 14.7)4.0
...
See also:
Turn Signal Lamp Repair procedures
Removal
Door mirror turn signal lamp
1.
Disconnect the negative (-) battey terminal.
2.
Remove the mirror (A).
3.
Remove the outside mirror cover (A).
4.
Remove the lower cover (A) of ...
Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and Inoutput
IDB terminal function
Connector [CLG02]
Pin No.DescriptionConnected to1-?2-?3-?4-?5-?6-?7-?8-?9-?10-?11-?12-?13-?14-?15-?16Injector (Cylinder #3) [Low] control outputI ...
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...