Hyundai Equus Manuals

Hyundai Azera: Intake Air Temperature Sensor (IATS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Intake Air Temperature Sensor (IATS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the intake air temperature sensor connector (A).
3.
Remove the installation bolts (B), and then vertically remove the sensor from the air cleaner assembly.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.

Intake air temperature sensor:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Intake Air Temperature Sensor (IATS) Schematic Diagrams
Circuit Diagram ...

Manifold Absolute Pressure Sensor (MAPS) Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog si ...

See also:

Trunk Trim Repair procedures
Replacement     • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and ...

Changing the coolant
Have the coolant changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. Put a thick cloth around the radiator cap before refilling the coolan ...

Side Impact Sensor (SIS) Repair procedures
Removal Front Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the door scuff trim. (Refer to Body - "Door sc ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com