Hyundai Equus Manuals

Hyundai Azera: Power Window Motor Repair procedures - Power Windows - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Power Window Motor Repair procedures

Inspection
Front Power Window Motor Inspection
1.
Remove the front door trim panel.
2.
Disconnect the connector from the motor.

3.
Connect the terminal No. 2 and No. 3 to battery voltage (12V) and terminal No. 4 to battery (-). And then check that the motor operates smoothly when connecting the terminals below.
If the operation is abnormal, replace the motor.
[Safety Power Window]

Rear Power Window Motor Inspection
1.
Remove the rear door trim panel.
2.
Disconnect the 2P connector from the motor.

3.
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Power Window Motor Schematic Diagrams
Circuit Diagram Front Safety Window Rear Window ...

Power Window Switch Schematic Diagrams
Circuit Diagram Driver Power Window Switch (1) Driver Power Window Switch (2) Passenger Power Window Swich Rear Power Window Swich ...

See also:

Power Mosfet Repair procedures
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. 1. Drain2. Dr ...

ESC OFF Switch Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer the Body - "Crash pad lower panel") 3. Remove the crash p ...

Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between re ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com