Inspection |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
|
3. |
Remove the crash pad side switch assembly. |
4. |
Check the continuity between the switch terminals as the ESC OFF switch is engaged. |
Troubleshooting
Troubleshooting
ProblemPossible causeSolutionNot pairingBluetooth device of Car is not discoverable modeEnter Bluetooth pairing (searching) modeUser’s phone is Bluetooth off modeUser’s phone set ...
Rear Disc Brake Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Loosen the bolt & nut and then disconnect the shock absorbe ...
ICM (Integrated Circuit Module) Relay Box Components and Components Location
Component
Input/Output Specification
No.ConnectorNo.Connector1 -11 -2 -12 -3Burglar horn13 -4 -14 -5Engine room box(Horn 15A fuse)15GND6IPM(BCM : Burglar alarm h ...