Hyundai Azera: Power Mosfet Repair procedures
| Inspection |
| 1. |
Ignition "ON" |
| 2. |
Manually operate the control switch and measure the voltage of blower motor. |
| 3. |
Select the control switch to raise voltage until high speed.
Specification
*AUTO COOLING: Auto speed (4.5V~B+)
*AUTO HEATING: Auto speed (4.5V~11.3V) |
| 4. |
If the measured voltage is not specification, substitute with a known-good power mosfet and check for proper operation. |
| 5. |
If the problem is corrected, replace the power mosfet. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B).
|
| 3. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws.
|
| 4. |
Installation is the reverse order of removal. |
Blower Motor Repair procedures
Climate Control Air Filter Description and OperationCamshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form�
Removal
•
DON'T remove the camshaft posit ...
Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
Circuit Diagram (3)
SRSCM Connector terminal
Pin Function (Connector A)Pin Function (Connector B)1Ignition1Seat belt pretensioner [Driver] Hig ...
Components and Components Location
Components (1)
1. Roof side molding [RH]2. Roof side molding [LH]3. Movable glass assembly4. Wind deflector assembly5. Panoramaroof panel assembly6. Folding cover [RH]7. Decoration cover [RH]8. D ...