Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control
system. If there is no CKPS signal input, the engine may stop because of
CKPS signal missing. This sensor is installed on the cylinder block or
the transaxle housing and generates alternating current by magnetic flux
field which is made by the sensor and the target wheel when engine
runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coola ...
Specification
ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)]Air Gap (mm)0.5 ~ 1.5
...
See also:
Occupation classification system
Your vehicle is equipped with an occupant classification system in the front
passenger's seat.
The occupant classification system is designed to detect the presence of a properly-seated
front ...
Sub Frame Repair procedures
Replacement
1.
Remove the front wheel & tire (A).
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
•
Be careful not to damage to the hub ...
A/C Pressure Transducer Repair procedures
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals.
2.
Inspect the voltage value whether it is sufficient to be regular value ...