Hyundai Azera: Engine Coolant Temperature Sensor (ECTS) Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the ECTS connector. |
| 3. |
Remove the ECTS (Refer to "Removal"). |
| 4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. |
| 5. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the air cleaner assembly.
|
| 3. |
Disconnect the engine coolant temperature sensor connector (A). |
| 4. |
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
|
| 5. |
Supplement the engine coolant.
|
| Installation |
|
|
|
| 1. |
Installation is reverse of removal.
|
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Crankshaft Position Sensor (CKPS) Description and OperationTPMS Sensor Description and Operation
Description
1.
Mode
(1)
Configuration State
A.
All sensors should be in the Low Line state.
B.
In High Line configuration, sensor transmissions occur every 1 minute (nominal) and pressure ...
Repair procedures
On-vehicle Inspection
Spark Test
1.
Remove the ignition coils.
(Refer to Ignition System - "Ignition Coil")
2.
Using a spark plug socket, remove the spark plug.
3.
Install the spark p ...
Radial-ply tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother
high speed ride. The radial- ply tires used on this vehicle are of belted construction,
and are selected to compleme ...