Hyundai Equus Manuals

Hyundai Azera: Crankshaft Position Sensor (CKPS) Description and Operation - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Crankshaft Position Sensor (CKPS) Description and Operation

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed on the cylinder block or the transaxle housing and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).

Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coola ...

Crankshaft Position Sensor (CKPS) Specifications
Specification ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)]Air Gap (mm)0.5 ~ 1.5 ...

See also:

Components and Components Location
Component 1. Driver airbag (DAB)2. Remote control assembly3. Steering wheel body4. Wiring5. Lower cover ...

Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high ...

Brake fluid
Check brake fluid level in the brake fluid reservoir. The level should be between “MIN� and “MAX� marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3 or DO ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com