Hyundai Azera: Crankshaft Position Sensor (CKPS) Repair procedures
| Inspection |
| 1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the air cleaner assembly.
|
| 3. |
Disconnect the crankshaft position sensor connector (A). |
| 4. |
Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
|
| Installation |
|
|
|
| 1. |
Installation is reverse of removal.
|
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Camshaft Position Sensor (CMPS) Description and OperationSchematic Diagrams
MDPS Circuit Diagram
Harness Connector
TypePin NoDescriptionBattery1Battery +2Battery -Vehicle1IGN2-3-4-5-6-7High_CAN8Low_CAN
...
SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Smart key unit Components and Components Location
Component (1)
Connector Pin Information
PinConnector AConnector BConnector CConnector D1Power GND1ACCRF dataAntenna power - LH2Power GND2IGN2C CAN lowAntenna power - RH3-Stop lamp fuseB CAN lowAnt ...