Hyundai Equus Manuals

Hyundai Azera: Shift Lever Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Shift Lever Repair procedures

Removal
1.
Remove the center console assembly.
2.
Remove the duct (A).

3.
Disconnect sports mode connector (A).

4.
Remove the shift cable (B).

5.
Remove the wiring (A).

6.
Remove the shift lever assembly (B) by removing the bolts (A-4ea).

Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

7.
Installation is the reverse of removal.
   
Make sure vehicle does not roll before setting room side shift lever and Automatic Transaxle(AT) side manual control lever to "N" position.
Shift Lever Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly 3. Control cable assembly4. Manual control lever (T/M side) ...

Shift Cable Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly 3. Control cable assembly4. Manual control lever (T/M side) ...

See also:

Specifications
Specifications ItemSpecificationFront/Rear parking assist system control unitRated voltageDC 12VOperation range30~120 cm(11.8~47.2 in)Operation voltageDC 9V~16VOperation currentMax. 300 mAOperati ...

Components and Components Location
Components 1. Main crash pad assembly2. Side speaker grille [LH]3. Center speaker grille4. Side speaker grille [RH]5. Alarm speaker assembly6. Center speaker assembly7. Photo sensor 8. Crash pad ...

Center Muffler Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. (Refer to Engine Electrical System - "Battery") 2. Remove the catalytic converter & center muffler assembly (A). ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com